Poolife pH Minus - 7 LBS

Overview:
POOLIFE™ pH Minus is a white, granular form of sodium bisulfate (dry acid). POOLIFE Minus is equally effective at lowering your pool’s pH levels or lowering total alkalinity (TA), depending howthe product is applied.

Application: 

• To Lower pH
• While water is circulating, broadcast widely over the deep end of the pool.
• If you would like to pre-dissolve and add pH Minus as a liquid, add the liquid as you walk around the sides of the pool.

Dosage/Frequency:

To Lower pH: Try to keep your pH levels between 7.2 – 7.8.
• Use this product if pH goes above 7.8.
• Proper dosages will vary.
• The proper dosage is determined by your current pH.
• First, test current pH. Then refer to product label for proper dosage to adjust pH.

• To Lower Total Alkalinity: Add the product in one localized area at the deepest end of the pool. This will create a localized pocket of low pH, which will lower your total alkalinity.
• Total alkalinity (TA) should be in the range of 80 – 120 ppm.
• If using POOLIFE Primary Chlorinators (color code yellow), try to keep TA at the low end (60 – 100 ppm.)
• If routinely using POOLIFE Primary Stabilized Chlorinators (color code orange), try to keep TA at the high end (90 – 120 ppm.)
• Adding 2 lbs. per 10,000 will lower TA by 10 ppm.
• Do not exceed 2 lbs. per 10,000 gallons per day.  If additional adjustment is needed, add the following day.
• IMPORTANT: Remember, do not broadcast. The key is to add the acid in one isolated area.