| 2 HP, full-rated square flange Emerson motor engineered to provide significant energy savings. Emerson consistently produces motors that set the standard for water system pumps. Some of these standards include the following: easy-access cover, easy access/locking for removal and installation of impeller, corrosion resistance, five-point mounting, and long motor life. - Energy Saving - 18% less energy than standard equivalent hp motors
- Thermally Protected
- Continuous Duty Design
- 6.5" Diameter Body, 56Y FRame
- Triple Bearing Protection
- Stainless Steel Threaded Shaft
Energy Savings Chart:
Estimated savings (vs. standard motors) over 6 months if you run your pump 24 hours a day. Based upon the following average electrical KW rates: - @$.06 KWH = $43
- @$.08 KWH = $57
- @$.10 KWH = $72
- @$.12 KWH = $86
Check with your local utility for rates to get an accurate comparison. Specifications:
Runs on 208 to 230 voltage
208V, 10.6 amps
230V, 10.0 amps HP: 2.0
SF: 1.30 - Full-rated Motor
FR: 56Y
Length Less Shaft: 13"
Weight: 35 lbs. This 2 HP motor replaces these and other motor model numbers: - Emerson: EB843, EB840, EB748
- G.E: C1284 (2.5 HP)
- A.O.Smith: USQ1252 (2.5 HP)
- Magnetek/Century: B840 (2.5 HP)
- Franklin: 13280 (2.5 HP)
- Sta-Rite: A100G5LL (2.5 HP)
This motor is common to the following pump makes/models: - American Products Ultra-Flo
- Aqua-Flo Dominator
- Pac Fab/Pentair Challenger
- Purex/Pentair Whisperflo
- Sta-Rite Dura-Glas & Max-E-Glas (not Dura-Glas II)
- Sta-Rite Max-E-Pro
- Others
Important Note When Replacing Motors: If you are replacing a motor that has a low service factor (S.F.) of 1.0 to 1.25 (this is referred to as an uprated motor), you will need to select a energy saving motor that is ONE size smaller in HP to provide the same net horsepower. -
For example: If the motor being replaced is a 2.5 HP and has a S.F. of 1.0 - 1.2, you should choose this 2 HP full rated motor to provide the identical net horsepower output. If the motor you are replacing is a 2 HP with a S.F. of 1.30, you should select the 1.5 HP Energy efficient motor to maintain the same hp output. The result of choosing a full rated motor is that you'll get the same pumping output using a smaller rated HP that consumes far less energy.
|
