Immersion Baptistry Heater

240 Volts Single Phase
Especially Designed For Easy, Low Cost Installation

Applications:
Ideally engineered for Fast Heat-Up in
Water - Alkaline - Plating - Bath Heating

Construction Features

• Immersion section of unit made of Incoloy or Stainless Steel.
• All heat confined to the formed horizontal section for optimum heat efficiency.
• Cold riser extends to the top of container where control housing is located.
• 3-Conductor cord set with polarized plug included for easy installation and wiring at no extra charge.
• Adjustable vapor-proof thermostat control with temperature range off - 55°F to 115°F (± 3°).
• Hi-Limit cut out switch set at 125°F (±4°).
• Stainless steel mounting bracket also supplied for easy mounting.
• Pilot light and on-off switch provided, indicates desired temperature when reached and breaks circuit when element is not in use. Saves electricity - Saves money.

Notes:

• Completely automatic and portable - just plug in 42" Power Cord and operate.
• No cutting or damage to your present container.
• Although portable - your container may be cleaned without removing unit.
• Unit can be suspended in middle, end or side of container.
• No contractors required on standard SS-6-42HL Models
• The SS-6-42HL (6KW) will heat 60 GPH (40° R). A 750 to 1,000 gallon Baptistry can be heated in 13 to 17 hours, or one-half this time 20 degree rise in temperature.
• Heater can be operated on 120 volts, but power will be reduced to 1.5KW and will heat 15 GPH (40°R) or 30 GPH (20°R)